When replacing the air filter element in the loader accessories, pay attention to the corresponding problems in order to get a better pass in the future use. Every note is more important. The following is the handling of this issue, let's take a look.
When cleaning or replacing the air filter element, the parts must be matched one by one to prevent foreign matter from falling into the intake valve. Usually, check whether the air intake expansion pipe is damaged or flat, and whether the connection between the expansion pipe and the air filter inlet valve is loose or leaking. If found, it must be repaired and replaced in time. When installing or replacing the oil-gas separation filter element, care must be taken to ensure that all conditions are correct, such as properly rotating the seal (anti-static measures must be taken) to drain the remaining oil in the oil return pipe, and the oil return pipe must have sufficient length to reach the bottom end cover. When installing and replacing the filter element, it is important to ensure that the oil in the separation tank and the dry side of the oil filter element are clean. The surface of the filter element separation layer is easy to operate, thereby increasing the oil carrying capacity and reducing the efficiency. The impurities on the dry side of the filter element block the oil return pipe. Road, causing the phenomenon of air-borne oil. The design failure pressure of the filter element is 4 bar. After the compressor is boosted, the calculation valve should be opened gradually until it meets the requirements of the load gas consumption. Sudden emptying is strictly prohibited, which will cause the filter element to rupture, flatten the filter element, and carry a large amount of oil. If it is used beyond the design flow range of the oil-gas separation filter element, the oil-carrying capacity will inevitably increase.
As a common loader accessory, the air filter element should be replaced every 1000-1500 hours under normal conditions. It is recommended to replace the air filter every 500 hours in places with particularly harsh environments, such as mines, ceramic factories, and cotton spinning factories.
