1. When the loader is operating on the beach
Some loaders work on the beach, and some work in sea water.
In this case, after the loader operation is completed, be sure to rinse the parts of the loader that have been in contact with the salt water with water, and pay attention to whether the electrical parts are corroded. After the cleaning is completed, conditionally use oil to maintain the exposed metal, and then lubricate the various operating equipment and components of the loader to check whether each part is loose or damaged. If found, it must be dealt with in time. If you do not pay attention to the maintenance operations of the loader's operation on the beach, it may cause the loader's metal to corrode, which greatly affects the loader's operating conditions.
2. When the loader is operating in the severe cold area
Loaders are also used in winter construction in northern China.
At this time, pay attention to the following problems. First, the oil should be selected from high-quality cold-resistant fuel, and pay attention to the label of the oil.
Then, add antifreeze to the cooling water used by the loader, otherwise it will freeze the water tank. Third, the battery should be charged and discharged more often to avoid freezing of the electrolyte.
3. When the loader is working in the field
There are many loaders working in the field, and the dust on the construction site is also particularly large. In this case, the air filter of the loader should be replaced earlier than normal to ensure the normal operation of the engine. When there is a lot of dust, the radiator of the loader will easily deposit dust and affect the heat dissipation. So use clean water to clean the radiator of the loader. The earlier replacement of the diesel filter is the same as above. Pay attention to cleaning the starter and generator rectifier.
There are now many mines that also have loaders in operation. There are many mountains and rocks. At this time, pay attention to the chassis of the loader and the four-wheel belt, and pay attention to whether it is loose or damaged.
It is better to check the tension of the track than on the flat ground. When working on the mountain, the working equipment of the loader will be damaged faster. It is necessary to pay attention to the selection of enhanced loader working equipment and replace it in time.
