The use of the loader is not static. If the usage is too long, a series of situations will occur. In this case, people often do maintenance. In my opinion, when I heard the entire machine is very weak, the behavior of immediately replacing the pump is an irresponsible behavior.
The entire machine is weak. If the shovel and sports cars are relatively weak, they should check the power source from the beginning, because if the diesel power is insufficient, no matter how you repair the working system, it is useless. Some repair workers will connect the throttle line regardless of the pressure of the throttle, regardless of the pressure of the throttle. Therefore, the repair diesel engine cannot solve the result of the weakness.
"Gate Soft Shaft", all the soft shafts used by the diesel engine factory are all installed, but the structure and appearance are the same. When pulling the wire in the left buff, the rubber sleeve of the left red circle has been extended, and the rubber sleeve of the right red circle has been shortened. When the left steel wire pressure, the left red ring rubber is shorter, and the right rubber sleeve is elongated, and a puller is equivalent to loosening the diesel door and the throttle of the driving room.
The correct connection method of the accelerator pedal is to tighten the aluminum connector, push the wire to the bottom, and then nature to tighten the two joint caps in accordance with the state at this time, and do not pull the jack movement of the soft shaft. At this time, the tie rod of the throttle pedal is vertical. The connection of the diesel engine This is the same as below the cab. The aluminum joint is tightened in natural state, and then the fixing cap of the jacket is tightened in the natural state. When you step on the throttle in the cab, the limit block must touch the limit screw at the arrow.
