Adjust the free trip of the clutch pedal. The gap between the rod and the separation bearing is 2 mm, referred to as the separation gap, and the corresponding pedal free travel 30mm. If it does not match, the two lock nuts on the lever can be released, then turn the tedler, change the length of the lever to meet the requirements of the release gap. After adjustment, tighten the lock nut.
Adjust the release lever position. When the clutch is mounted, the distance between the end faces of the separation rod must be (891) mm, while the inner end surface of the three separation rods is within the same plane perpendicular to the axis, and the mutual difference is not more than 0.2 mm.
During the loading machine clutch, if the clutch is not completely separated, accelerate the wear of the friction plate, the life of the loader will be greatly reduced. Therefore, when adjusting, targeted adjustments to extend the life cycle of the loader according to the specific situation. The closing release time should not be too long, generally no more than 15-20 s. When the clutch is separated, quickly move, step on, completely separated. When the clutch is joined, the pedal is slowly released, and it is gently engaged gently. Do not use clutch semi-separated methods to control the speed of the vehicle to avoid rapid wear of friction sheets and separation bearing. At the same time, do not place your feet on the clutch pedal when driving.
