Note: The engine is low-speed operation before the engine oil pressure indicator is turned off. If the indicator light does not extinguish in 10 seconds, the engine should be stopped, and the reason should be identified before starting again. Do not rule out the failure causes the engine damage.
Note: The handle of the hydraulic locking device must be in the unlocked position before the hydraulic manipulation device.
1. At least 5 minutes of at least 5 minutes in the engine preheating and separating the joystick controller. To accelerate the preheating of the hydraulic part. When the excavator is preheated, please follow the suggestions: 2. For preheating hydraulic oil, The engine speed knob to the medium engine speed. Make the engine to move the joystick.
3. Turn the engine speed knob to the maximum speed of the engine and repeat step 2.
4. Circulate all joysticks to flow into each hydraulic oil into each hydraulic cylinder and hydraulic oil.
5. Pay attention to you and indicators at any time when operating.
The closure of the Cat 325 excavator fuel tank and the discharge control device fuel discharge valve is located below the main hydraulic pump. The fuel tank is closed below the fuel tank.
Fuel tank discharge valve → turn counterclockwise to the fuel discharge valve to discharge water and precipitate in the fuel tank. Turn the fuel discharge valve closes the fuel discharge valve.
Fuel tank close valve → Temple to turn the fuel closure valve to cut off the fuel supply. Return the fuel closure valve counterclockwise to turn the fuel supply.
